Chapter 2
CellPipe
20H User Guide
19
Configuration will have no effect until after save and
restart.
All the parameters will not be effective under the setting
being saved and restart again. Above message is to
remind operator.
4.3.3
Nat function
This function will enable PC users in your LAN
environment to access outside with only one IP address
(IP sharing) and one access account.
Use the following example to enable NAT function for
IPoA routing.
> pat ( with “enter” key to go to pat director)
> pat>setpat 192.168.1.3 enable
> pat>setpat 192.168.1.3 enable
(enable NAT function for IPoA routing for specific WAN IP
address. Replace WAN IP address with the specific
address set for IPoA routing in this example. You have to
repeat this command if more than one PVC had been
configured)
(Use the same command with “disable” attribute to
disable NAT function)
If you have any application or server in your LAN
environment which is available for outside uses, please
configure the PAT (port address translation) table to
enable this kind of service by following the example
below, otherwise continue to section 4.3.4
Use the following example to add PAT table for IPoA
routing. The word with background “
“ is prompt
following by a command required
> pat> addpatin 192.168.1.3 434/udp 210.18.35.10
(Addpatin – command for add incoming pat table)
