LS ELECTRIC eXP2 Series, User Manual, Page: 31 / 129

Chapter 3 Standard Specification
3-6
Note
(1) Caution in power connection
: With AC power applied to DC power device, it may cause product damage or fire.
Please pay a special attention to connection.
(2) PE Connection
: For the device PE, please use
⑦
PE terminal in the Chapter 2.1.
(3) Battery discharge-prevention DIP switch
: In order to prevent the battery discharge, turn off the DIP switch No.1.
To use backup function, please turn on DIP switch No. 1.
(4) Battery Operation and Life
: Battery is used for RTC (date/time) when the power of device is off.
Battery is not consumed with power applied.
(5) Battery Replacement
: The battery must be replaced with CR 2032H.
(6) LCD Backlight Replacement
: Please replace LCD if you want to replace LCD backlight.
(7) Protection standard
: XGT Panel is designed by IP65 Standard in front parts. Ingress Protection (IP) is based on the IEC 60529
Standard for degrees of protection provided by enclosures. But XGT Panel does not guarantee from all
installation environment.(Indoor use only) When installing panels, make sure that dust and moisture are
not brought in. For more details on installation, See Chapter 10.installation and Wiring.
(8) USB does not recommend using an extension cable. If it is inevitable to use an extension cable, the
length of the cable should be within 2 meters and should be used in an environment where there is no
noise interference.
(9) Maximum supported capacity of USB memory and Micro SD card
: USB memory 32GB (Format -> FAT32)
※
For stable USB memory use, it is recommended to use USB 2.0 driver.
Micro SD card 32GB (Format -> FAT32).