9. Other Precautions and Information
1. Do not remove the SD card during printing.
2. The temperature suitable for PLA is 190
℃
~220
℃
. The optimum
temperature may depend on the manufacturers. Please set the
optimum temperature when generating g-code.
3. To avoid malfunction, there should be no more than 30 files in a
folder, including subfolders themselves.
4. Make folder and file names as short as possible.
5. The file name must be within 50 characters including the extension.
6. Sometimes the machine may reboot during operation in order to
prevent malfunction. This is normal behavior so do not worry. The
machine will NOT reboot while printing.
7. All products are provided after quality inspection. There can be some
filament remnants in and around the nozzle, which is due to the
quality inspection.
8. The estimated time that Cura shows can be different from the actual
time.
9. There are g-code files in the SD card we provided. You can also enjoy
with these files.
29
LOCOOP Y USER MANUAL | www.locoop.net
“Enjoy Your LOCOOP Y”
Summary of Contents for Y
