When auto-leveling is complete, place a piece
of paper between end-effector and bed.
Tap on the second or third icon on the screen
above to move the nozzle down until the
paper would not pull out smoothly. Then, tap
on the second icon to move the nozzle up by
0.05mm. Tap on the far right 'Save & Exit'
icon to finish calibration.
2. Calibration
Insert an SD card in the slot and
press the far right icon. This is
necessary job for saving calibration
data to the SD card.
When replacing the SD card, you
will need to repeat this process.
To begin auto-leveling, tap on the
far left icon and wait. The other two
icons will become activated once
auto-leveling is complete.
When you see the screen change
like this, tap on the left icon to
begin height calibration.
21
LOCOOP Y USER MANUAL | www.locoop.net
Summary of Contents for Y
