9. Attaching End-Effector
1. Plug the wire to the connector.
2. Insert the PTFE tube deep into the center hole.
3. Attach both ends of the 6 lower arms to the steel balls of upper arms
and end-effector, respectively.
4. Attach the tube holder to a bar and put the wire inside the tube
holder.
5. Connect power on the left panel using the adopter.
Now the hardware assembly is complete. Be sure to read the manual in
the next section, before using the product.
18
LOCOOP Y USER MANUAL | www.locoop.net
←1
2→
←3
←4
Summary of Contents for Y
