8. CURA Download & Setting
https://ultimaker.com/en/products/
cura-software/list
Download the latest version of
CURA (version 15.X) from the above
link.
Run CURA. From the top menu, select 'Machine
Add new machine' to
run the Configuration Wizard. Click Next, select Other, and then click
Next again. Click Custom, and then click Next.
Enter LOCOOP Y in the machine name, and enter 180 mm for width, 180
mm for depth, 200 mm for height, and 0.4 mm for nozzle size. Then
check out Bed center is 0,0,0 and press Finish to finish.
You can enter the printing
condition by clicking the Basic
Tab on the left of CURA.
The
general
settings
for
LOCOOP Y are shown on the left.
You can adjust the layer height
between 0.05 and 0.3 mm and
the printing temperature bet-
ween 190 and 220 ° C. The
filament diameter and nozzle
size should be fixed to 1.75 mm
and 0.4 mm, respectively, and
should not be modified.
-
G-code Generation
: Open
the 3D model you want. Click
'File
Save Gcode' to save
the Gcode with the name you
want. Move this file to the SD
card and insert it into the
printer. The printing is ready.
28
LOCOOP Y USER MANUAL | www.locoop.net
Summary of Contents for Y
