1. Troubleshooting
The Printout
does not Stick
well to the Bed
- The distance between nozzle and bed might be too
far. Please adjust the gap again (See page 21,
Calibration part.).
The Nozzle
Seems to be
Clogged
- First, check if the filament on spool is twisted. If it is,
please untangle the spool and try again.
- Heat up the nozzle and try to force the filament by
hand, while pressing the red spring presser on the
extruder.
- If still clogged, pull the filament out of the extruder
with the hand, then cut off the bulged end of the
filament and reinsert it.
- If the problem persists, please use the enclosed
nozzle cleaning needle to drill directly.
31
LOCOOP Y USER MANUAL | www.locoop.net
Summary of Contents for Y
