LNS Sprint 545 S2, Instruction Manual

Page: 38 / 114

4-16 CHAPTER 4: ELECTRICS
SPRINT 545/565S2
4. INTERFACE
Before connecting, check to make sure that the voltage of the bar feeder corresponds to
the one provided by the lathe. The supply voltage of the bar feeder is indicated on the
identification plate (A).
4.1. Description
The interface cable(s), between the bar feeder and the lathe is (are) provided by LNS.
Although an example of an interface diagram is provided, the diagram for the interface corresponding to
your device, essential when making the electrical connection, is located inside the electrical cabinet.
When making connections, ensure that the cables are long enough to allow the entire travel of the
retraction system (250 mm) to be used.
Should the interface instructions not be observed during start-up, the damaged elements
as well as the resulting damages are not covered by warranty.
A