LNS Sprint 545 S2, Instruction Manual

Page: 22 / 114

3-6 CHAPTER 3: SYSTEM START UP
SPRINT 545/565S2
3. ANCHORING
Once the bar feeder is in place and perfectly aligned, it should be anchored to the ground to make it
stable. Four anchorage points
(A) have been provided on each foot for this purpose. Eight anchoring
bolts (B) must be provided by the customer (minimum M10 x 100 mm).

Once the anchoring bolts are tightened, check the alignment again, and correct it if necessary.

Tighten the nuts of the levelling screws.

Remove the 2 support plates from the bar magazine.

Remove the 4 retaining screws (C) behind the rear foot.
4. CONNECTIONS
When the bar feeder is correctly aligned and anchored to the ground, its interface with the lathe and the
compressed air must be connected. The hydraulic reservoir can be filled.

For electrical connections, please refer to Chapter 4 – Electrics.

For pneumatic connections, please refer to Chapter 5 – Pneumatics.

To fill the tank, please refer to Chapter 6 – Hydraulics.
B
A
C
C