LNS Sprint 545 S2, Instruction Manual

Page: 94 / 114

8-22 CHAPTER 8: HANDLING
SPRINT 545/565S2
4.2.5. Language
This parameter allows to adapt the language in which
the messages will appear, depending on the country
of destination of the bar feed system
(for practical
reason, it is not necessary to stop the bar feeder to
select a language)
.
4.2.6. Miscellaneous functions
Request for reference point
This operation allows the bar feeder to find the original
parameters and positions of the servo motor if these
have been lost.
Front rest settings
This parameter allows calibrating the front rest. It also
allows activating or deactivating the front rest (symbol
close then symbol open).
Two icons allows for opening and closing of the front
rest, thus easing the possible replacement of the
elements.
The protection cover must be opened before entering this parameter.
Clamping mode reversed (may be not visible)
The interface signal is reversed depending on whether
the clamping device functions by pushing or by pulling.
When changing clamping unit, the interface signal that
indicates opening and closing is reversed. At this
point, the bar feeder will incur an error.
Mechanical closing/opening time for the clamping
system (may not be visible)
For clamping with a mandrel, a closing/opening time
may have to be configured to prevent the lathe starting
up before the unit has closed/opened completely.