LNS Sprint 545 S2, Instruction Manual

Page: 103 / 114

CHAPTER 8: HANDLING 8-31
SPRINT 545/565S25
6
[+/-]
[+/-]
by offset correction:

Press the key corresponding to the icon [+/-] .
The current top cut position (z) is displayed.

Press the [+] icon to add the value, or the icon [-] to subtract it. The
new value is stored.

To exit the top cut position set mode, press the key attributed to the
icon [ESC] .
Jump to point 8.
7
[TEACH IN]
[START]
[REW] [FWD]
[ENTER]
[TEACH IN] By teaching:

Press the key attributed to the icon [TEACH IN] .

Press the key attributed to the icon [START] .
The loading channel raises and grasps a bar as it passes by.
The feeding pusher inserts the bar into the lathe spindle.
The feeding pusher returns to its reference position.
The feeding pusher is now facing the spindle.

Press the key [FWD] and advance the pusher to the desired
position (see previous page). Correct if necessary with the
key [REW].

To validate the new end of bar position, keep [ENTER] pressed
until the screen blinks.
8
[ESC]
or
[STOP]
To exit the set mode, press the keys
[ESC] or [STOP] .
11. POWERING DOWN
Before handling the bar feeder, stop the lathe at the end of part cycle !
When powering off the device, make sure the
carriage is in the rear position, the pusher is
retracted and there is no bar present in the guiding
elements.
To power down, turn the switch to the left, to the
0-off position.