38
LNC woodworking Machine Series Operation Manual
寶元數控
LNC Technology Co., Ltd.
Dust-removal
4.5.
4.5.1.
Dust-removal of single station
1. The dust-removal actions in the single-station system is the same as the uploading actions.
When used, it is to call M17 or trigger one-key uploading button.
2. The related parameters setting of single-station dust-removal is located in the project
parameters in the user parameters.
Parameter
No.
Parameter Content
8324
[Unloading/dust-removal function] Pushing dust-removal cylinder up and
down in-place inspection (0: no inspection, 1: up in-place, 2: down in-place,
3: up and down in-place)
8325
[Dust-removal function] Dust-removal speed (KLU/MIN)
8332
[Unloading function] Mechanical coordinates of the starting point of
uploading (LU)
8333
[Unloading function] Mechanical coordinates of the end point of uploading
(LU)
8334
[Loading / unloading function] Loading and unloading direction (0:X axis,
1:Y axis)
8336
[Dust-removal function] Dust-removal direction (0: X axis, 1: Y axis)
4.5.2.
Double-station dust-removal
4. There are two modes for double-station dust-removal.
i.
When the machine is standby, the dust-removal of the station will be performed
immediately after pressing the dust-removal button corresponding to the
station.
ii.
When machining, press the dust-removal button corresponding to the
non-machining station, and wait until the tool lifting during machining (Z-axis
position is greater than the set value), the dust-removal action will be performed
in the non-machining zone. After the dust-removal is completed, the original
state will be restored to continue the unfinished machining.
5. The setting of the relevant parameters of the double station dust-removal is located in the
project parameters in the user parameters.
Parameter
No.
Parameter Content
8324
[Unloading/dust-removal function] Pushing dust-removal cylinder up and
down in-place inspection (0: no inspection, 1: up in-place, 2: down in-place,
3: up and down in-place)
