LK Floor Heating | Assembly Instructions | LK Room Temperature Control ICS-RF8
3
EN.33.C.891008
Quick Guide – programming the thermostats
1. Check that the radio link cable is connected to the receiver's RF input
2. Press the L key on the receiver unit for at least 3 seconds, the L-LED will light green.
3. Remove the plastic insulation from the thermostats battery compartment; the thermostat display shows
RUR.
4.
Press
Mode
until
shows in the display.
5. The receiver units’ L-LED switches to yellow and selectable channels light up green.
6. Select a channel by pressing a desired channel key; the selected channel flashes green.
7. Confirm by pressing Mode on the thermostat; the thermostat switches to "normal view".
8. Repeat steps 3-7 for other thermostats.
9. Once the programming is complete, press the L key in the receiver unit once to finish the sequence.
NOTE:
If necessary, the thermostat and the receiver unit can be
restored to factory settings. See instructions under the
heading
Reset
.
NOTE:
If the installation consists of several receivers which are
controlling a single pump, please read section titled
BUS
first.
NOTE:
Please read the section
Checking Signal Strength
before
starting the system.
Quick Guide – start-up
Once, steps above are completed, room temperature can be set on the thermostats:
1. Press right arrow to increase temperature.
2. Press left arrow to decrease temperature.
3. After some seconds, the display will revert to showing the room air temperature.
NOTE: For further information, please read
In-depth description of LK ICS-RF
. .