LK Floor Heating | Assembly Instructions | LK Room Temperature Control ICS-RF8
18
EN.33.C.891008
1.
Press
Mode
until
flashes, confirm with
Mode.
2. Press the right arrow until
LOCK
is shown in the display, confirm with
Mode
.
3. Select
ON/OFF
with the left/right arrow, confirm with
Mode
.
4.
The padlock
is shown in the display.
When key lock is activated, unlock the thermostat as follows:
1. Press all three keys at the same time for at least 20 seconds.
2. The padlock icon disappears and the thermostat is "open" again.
Remote control
The receiver is equipped with an input marked "Setback". The input can be used by an external signal such as
the GSM switch to lower the temperature of the entire system. (Closed contact = reduction) The setback
temperature is preset to +12°C.
The temperature can be changed for individual thermostats as follows:
1.
Press
Mode
until
flashes, confirm with
Mode
.
2. Press the right arrow until
SET
(Setback) is shown in the display, confirm with
Mode
.
3. Select temperature with the left/right arrow, confirm with
Mode
.
Repeat the above for other thermostats in the system.
External sensors – connection of an external sensor
The thermostats can be equipped with external sensors, for example, to regulate the temperature from the floor.
