LK Floor Heating | Assembly Instructions | LK Room Temperature Control ICS-RF8
28
EN.33.C.891008
1. Switch the repeater off (if it is powered up).
2. Press the L key for at least 3 seconds on the receiving device. The L-LED should light green.
3. Connect the repeater to a 230 volt outlet.
4. Wait until the repeater starts flashing orange.
5. Confirm by pressing the L key.
NOTE:
A non-adapted repeater flashes green every 3 seconds.
Reset
Resetting of LK Receiver Unit ICS-RF8
If necessary all adapted channels can be erased from the receiver unit:
1. Press A and channel 8, together for at least 5 seconds.
2. LEDs for channels 1-8 are red for a short time
3. Unplug the unit for 10 seconds. (230 V power supply to unit).
4. The unit is now cleared of stored information.
5. Reset all thermostats.
Resetting of LK Thermostat ICS-RF
If necessary the thermostat can be reset.
1. Press the left arrow and right arrow keys for at least 5 seconds.
2.
DEFA
text flashes on the display, confirm with
Mode
.
3.
RUR
text appears in the display.
4. Remove the battery for at least 5 seconds.
5. The unit is now emptied of any information and is ready for new adaptation.
Resetting of LK Repeater ICS
If necessary the repeater can be reset.
1. On the back of the repeater there is a small orange reset key.
2. Press the key for at least 8 seconds.
3. A red LED lights up then the device is restored to its original state (factory setting).
System limitations
The following is a summary of the limitations of the system.
