LK Floor Heating | Assembly Instructions | LK Room Temperature Control ICS-RF8
13
EN.33.C.891008
1.
Press
Mode
until
flashes, confirm using
Mode.
2. Press the right arrow until
RFST
(radio signal strenght) appears in the display, confirm using
Mode.
Allow the unit stabilise for approximately five minutes.
3. Read the value. The device will automatically return to normal view after 30 minutes.
4. Repeat steps 1-3 for other thermostats in the system.
Signal strength can be checked for all units simultaneously to save time.
Signal strength
Comments
0-20
Too low to ensure their
functioning. Take action.
21-100
Excellent.
If necessary, the signal can be improved by placing the thermostat closer to the receiver unit, if possible.
Alternatively, the radio link can be moved by using the LK Antenna Cable. If the problem persists, the signal
is strengthened by use of LK Repeater.
System clock
The unit is equipped with a "system clock". For the weekly program to function, the unit's system clock must
be set. This can be performed from any thermostat in the system. NOTE: the time set applies to all the thermostats
in the system.
Set the system clock as follows:
1.
Press
Mode
until
flashes, confirm using
Mode.
2. Press the right arrow until
SySc
(System Clock) is displayed, confirm using
Mode.
3. The hours flash, select the arrow left/right, confirm using
Mode.
4. Minutes start flashing, select the arrow left/right, confirm using
Mode.
5. The days start flashing, select the arrow left/right, (1=Monday, 7=Sunday) confirm using
Mode.
Weekly program
The unit includes a weekly program. The weekly program switches between either
Comfort
(day temperature)
or
Economy
(night reduction). Individual times for each temperature can be set up as follows below. The system
can also adjust the "start time" so that the correct temperature is reached at the right time with the adaptive
function activated (self- learning).
Weekly program - activate
The weekly program is activated as follows:
1. Press
Mode
for 4 seconds.
2. The display shows
Comfort
or
Economy
in the operating area of the display (see illus. 12 in the above
picture of the display).
3. Repeat the above for other thermostats to monitor the program weekly.