LK Floor Heating | Assembly Instructions | LK Room Temperature Control ICS-RF8
2
EN.33.C.891008
•
Timeless Scandinavian design
•
Thermostats with LCD display
•
Self-modulation technology as a standard
•
Thermostats in gloss white, gloss black or silver
•
Remote control via mobile phone (as addition).
•
Adaptive weekly programming
•
"Holiday" function
•
Logging/function & system analysis
•
Wired & wireless communications in the same control box
•
Valve exercise program
•
Pump logic
•
Heat source (e.g. boiler) control
•
Simple programming
•
Easy installation
Installation instructions
Quick Guide - installing receiver units and thermostats
1. Install the receiver adjacent to the Manifold. Ensure there is enough space below the unit to remove the
lid and that it is possible to connect LK ICS MEM Stick vertically downwards. If the receiver is mounted
in a steel cabinet it is recommended that the radio link is placed outside the cabinet. This is easily done
with LK Antenna Cable ICS (accessories).
2. Detach back-plate from thermostat by pushing central catch at the bottom of the back-plate (use screw-
driver, pen or similar). (Refer to illustration below to open the thermostat.) Fix thermostat back-plates
to internal walls approximately 1.5 m above the floor. Take care to orientate correctly; see arrow on the
back.
3. Avoid locations that will affect thermostat operation (e.g. direct sunlight and draughts).
4. Next cut LK Actuator connection cable to length (Receiver to manifold).
5. Connect each actuator cable to a green terminal plug (NOTE: maximum two LK Actuators per terminal
and a maximum of 12 LK Actuators per receiver unit).
6. Insert one terminal plug per actuator(s) into bottom row of Receiver unit.
7. Run actuator cables through anti-tension track.
8. Place the Radio link in its holder inside the receiver.
9. Activate thermostats according to
Quick Guide – programming the thermostats.
10. Once the programming is completed click the thermostats body into the back-plate.