Linhai M565Li T3 EFI, Service Manual

Page: 299 / 338

CHAPTER 6 BRAKES
M565Li T3 EFI SERVICE MANUAL 20.0
CHAPTER 6 BRAKES PAGE. 6- 9
REMOVAL/ REPLACEMENT
1. Removal caliper and hub. Apply heat to the
hub in the area of the brake disc mounting
bolts to soften the bolt locking agent.
2. Remove bolts and disc.
3. Clean mating surface of disc and hub.
4. Install new disc on hub.
5. and tighten to specified.
CAUTION: Always use new brake disc
mounting bolts.
Front Brake Disc Mounting Bolt Torque :
18 ft. lbs. (25 Nm )
6.9 FRONT CALIPER REMOVAL/ INSPECTION / INSTALLATION
CAUTION: The caliper is a non-serviceable Component; it must be replaced as an assembly.
NOTE:
If any special service needed, contact the ATV manufacture via the agent for the parts
and special instruction.
REMOVAL
1. Remove wheel, remove caliper from the
strut.
2. Loosen and remove brake hose(s) to
caliper. Place a container under caliper to
catch fluid draining.
INSPECTION
Inspect caliper body for nicks, scratches or
worn. Replace caliper as an assembly if any
problem exists.
INSTALLATION
1. Install caliper on hub strut, Apply Loctite™
242 to screw threads and Install new bolts.
Front Caliper Mounting Bolt Torque
18 ft. lbs. (25 Nm )
2. Install brake hose and tighten securely.
NOTE: In some versions of brake, there are 2
hydraulic circulates (for foot brake and hand
brake) in one caliper. Make sure you install
the right hose.
3. Bleeding and Install wheels, If new brake
pads are installed, burnishing procedure
should be performed. See
BURNISHING