Linhai M565Li T3 EFI, Service Manual

Page: 154 / 338

83
CHAPTER 3 ENGINE
M565Li T3 EFI SERVICE MANUAL 20.0
CHAPTER 3 ENGINE PAGE. 3-
●
To install by use new oil seal(17) and
“
O
”
ring seal (13)
●
To adjust Adjusting Spacer (14) if
replace any one of Crankcase (Right),
Driven Bevel Gear (9), Driven Bevel
Gear cover (15). Detail to check Bevel
Gear adjusting method
●
To tighten stop Nut(11) with thread glue
by standard torque and with lubricating oil
on Bearing (10) ,Bearing (12),Oil seal(17)
and “O” ring seal before install.
Bearing Stop Nut Torque
：
100~120N.m
Driven Bevel Gear
Nut Torque
：
140~160N
.
m
Bevel Gear Spacer Adjusting Method
●
To adjust spacer
①
and
②
if replace any one of
Crankcase, Bevel gear or Bevel Gear Cover.
Bevel Gear Adjustment
Measure Bevel Gear Backlash
●
To install Drive and Driven Bevel Gear
on the Crankcase.
To tighten the Drive Bevel Gear by straight
Screwdriver
③
with duster cloth
②
into
the Speed sensor hole
①
●
To install special tool
③
and dial indicator
④
Caution: Keep the Gear backlash and
contact surface within the proper
scope in order to best match the bevel
gear mesh