Linhai M565Li T3 EFI, Service Manual

Page: 74 / 338

CHAPTER 3 ENGINE
M565Li T3 EFI SERVICE MANUAL 20.0
CHAPTER 3 ENGINE PAGE. 3- 26
Inspection
●
Inspect CVT friction disk for wear and
damage. If any cracks or damages are
found, replace CVT with a new one.
●
Inspect drive belt for wear and damage.
If any cracks or damages are found, replace
drive belt with a new one.
●
Inspect drive belt for width, if width is out
of service limit, replace drive belt with a new
one.
Service Limit
： 33.5mm
Tool
:
Vernier Caliper
Installation
Reverse the removal procedure for
installation. Pay attention to the following:
●
Insert drive belt with a special tool , as
low as possible, between secondary sliding
sheave and primary fixed sheave:
●
Hold
/ driven wheel
with a special tool
and tighten the nut to the specified
torque.
Nut, / driven pulley
：
110~120N
.
m
●
Install
d
riving pulley and bolt. Hold the
driving pulley
with a special tool and tighten
the bolt to the specified torque.
sign