Linhai M565Li T3 EFI, Service Manual

Page: 311 / 338

CHAPTER 7 ELECTRICAL
M565Li T3 EFI SERVICE MANUAL 20.0
CHAPTER 7 ELECTRICAL PAGE.7- 7
4.lgnition spark gap

Disconnect the spark plug cap from the
spark plug

Connect the ignition tester 1 as shown.
2 Spark plug

Turn the main switch to "ON".

Check the ignition spark gap .

Check the spark by pushing the
starter switch, and increase the spark
gap until a misfire occurs.
MEETS SPECIFICATION
The ignition system is not faulty.
Minimum spark gap:
6mm (0.24 in)
OUT OF
SPECIFICATION
OR
NO SPARK
Tester (+) lead
→
Spark plug side

Tester ( — ) lead
→
High tension cord side

5.Spark plug cap resistance

Remover the spark plug cap.

Connect
the pocket tester (ΩX1 k) to
the spark plug cap.
NOTE:

When removing the spark plug cap.
do not pull the spark plug cap from
high tension cord.

Remove→Turning
counterclockwise

Connect
→
Turning clockwise.

Check the high tension cord
when connecting the spark
plug cap.

When connecting the spark plug cap,
cut the high tension cord about 5mm.
OUT OF SPECIFICATION
Spark plug cap
resistance:
10K
Ω
(20
℃
)
Replace the spark plug cap
CORRECT
*