Reconnect the BAM! sign and reconnect the four cables to the 8-port expansion board. Turn the USB Power bank on again to test all the flashing
lights are working OK.
62.)
We will now install lights above the eyes of the Joker slide. Disconnect the following hair sections from each side, then using a LEGO Removal
Tool, create gaps just underneath the eyebrows to allow you to disconnect the front end of the top section as shown below. Do not completely
disconnect the top of his head, just the front half.
Take
2x Blue 30cm Bit Lights,
group them together and create a curve, then thread the connector ends through the top of the face and down the
joker slide.
