19.)
Connect the seven flashing lights installed so far to a new
12-Port Expansion Board.
Connect the USB Power Cable to the expansion board
and connect up the usb power bank. Turn the USB Power Bank ON to test the flashing lights installed so far are working OK.
Note: If you experience any issues with the lights not working and suspect an issue with a component, please try a different port on the
expansion board to verify where the fault lies (with the light or expansion board). To correct any issues with expansion board ports,
please view the section addressing expansion board issues on our
online troubleshooting guide.
20.)
Disconnect the lights from the 12-port expansion board, then turn the Joker sign over as we will now neaten up the wires. Lay out the top left
corner wires as shown below (one to each side), then disconnect the black plate on the top of the sign. Lay the cable going across the right in
between studs before reconnecting the plate over the top as shown below:
Disconnect the green 2
×
4 plate and lay the right wire down underneath before reconnecting the green plate over the top.
