34.)
We will now install a Bit Light underneath the top of the arch window. First take out a
White 15cm Bit Light
and with the LED facing down and
cable to the right, place it in the centre of the base of a provided Trans Clear Plate w Rounded Bottom 2
×
2. Connect the trans clear plate
underneath the following red bricks in the below position, ensuring the Bit Light is securely in the middle of the trans clear plate.
Bring the Bit Light cable across and lay in between studs, then connect it to the 6-Port Expansion Board on top of the theatre room. Turn the USB
Power Bank ON to confirm the light is working OK.
Note: If you experience any issues with the lights not working and suspect an issue with a component, please try a different port on the
expansion board to verify where the fault lies (with the light or expansion board). To correct any issues with expansion board ports,
please view the section addressing expansion board issues on our
online troubleshooting guide.
35.)
Take the top section we removed in previous step and disconnect the flag pole. Take a
White 30cm Bit Light
and with the cable facing to the
left, place it over the grey stud. Secure the Bit Light in place by connecting a provided Trans Clear Round Plate 1
×
1 over the top, then reconnect
the flag pole.
