19
Models:
97TI, 95TI, & 93T
Tools Required: Standard Screwdriver, Phillips Screwdriver, Metric Hex Key Set, Side Cutters
Note:
Proceed with the following steps immediately after attaching the DISPLAY CONSOLE as described in the
97Ti, 95Ti Assembly Instructions
and
93T Assembly Instructions
. Do not install the ACCESSORY TRAYS.
1. Locate the CABLE CLIPS (a). Peel the
backing off the adhesive strips and
position the cable clips as shown. Press
fi rmly o n the cable clips to ensure proper
adhesion.
2.
Locate the REMOTE CONTROL (b).
Confi gure the remote control for
a vertical (c-V) installation. Secure
the REMOTE CONTROL to the
left end of the ERGO CROSSBAR
(4) as shown. Be sure the CABLE
TIES (c-v) are pulled tight and trim
the excess cable ties.
3.
Route the REMOTE CABLE (c) along
the inside of the LEFT UPRIGHT (1), up
through the CABLE GUIDE (d), through
the CABLE CLIPS (a) and out the
top of the REAR CONSOLE (R). Route
the REMOTE CABLE around the
console standoffs as shown.
4.
With the POWER CORD (e), COAXIAL CABLE (f) and I-R REMOTE CONTROL
CABLE (c) oriented in the top console notch as shown, connect the CONSOLE
CONNECTORS as instructed in the Assembly Instructions. Secure
the
FRONT CONSOLE (S) using the 8 previously removed
SCREWS (Q). Tighten the screws securely.
Note: ALL CABLES should be routed through the CABLE GUIDE (c)
located at the lower left of the REAR CONSOLE (R).
5.
If through-holes in the four CONSOLE BOSSES (g) are not present,
use a 5/16” drill from the top center of the four console bosses to create through-
holes.
Note: Be careful not to damage the threads of the brass inserts when drilling the
through-holes in the console bosses (g).
CAUTION: Wear eye safety equipment when drilling the through-holes in the console
bosses.
6.
Locate the four RETAINING SPACERS (h). Position the RETAINING SPACERS
over the CONSOLE BOSSES (g) as shown. Be sure the RETAINING SPACERS are fully nested over the structural
ribs
inside the REAR CONSOLE (R).
7.
Position the BRACKET TUBE (j) with the MOUNTING PLATE facing
upward as shown. Position two SCREWS (k) on either side through
the CONSOLE BOSSES (g). Install four NYLOCK NUTS (m) onto the
INSTALLED SCREWS (k) securing the RETAINING SPACERS (h) and
bracket tube to the rear console. Tighten the nylock nuts securely. Do
not overtighten the nylock nuts.
8.
Attach the ADAPTER BRACKET (AA) to the ATTACHABLE TV (n) to
the using four SCREWS (BB). Tighten the SCREWS to 6-8 in-lbs. Do
not overtighten the SCREWS.
Attach the ATTACHABLE TV to the MOUNTING BRACKET (o) using
four SCREWS (p) and WASHERS (q). Tighten the SCREWS to 6-8 in-
lbs. Do not overtighten the SCREWS.
c
f
e
c
b
1
S
g
Q
2
R
1
c
e
f
n
n
b
e
f
R
11
m
h
g
12
a
21
o
p
q
j
k
AA
BB
b
