15
Models:
CLST & 97T (Integrity Series)
Tools Required:
Standard Screwdriver, Phillips Screwdriver, Metric Hex Key Set, Side Cutters
Note:
Proceed with the following steps immediately after attaching the DISPLAY CONSOLE as described in the
Integrity Series Assembly Instructions.
Do not install the ACCESSORY TRAYS.
1. Insert one end of the AUDIO / VIDEO / I-R CABLE ASSEMBLY (a) into the console connector. Route the other end
through the HOLE (a1) on the right upright and through the GROMMET (a2). Continue routing the cable assembly
through the hole of the TV MOUNTING BRACKET END CAP (a3), through the TV MOUNTING BRACKET TUBE
(g), and exiting through the CENTER HOLE (a4) of the TV MOUNTING BRACKET TUBE (g).
2. Route the POWER SUPPLY CORD (b) and COAXIAL CABLE (c) through the left upright, out the HOLE (b1) on the
left upright and through the GROMMET (b2). Route the cable through the hole of the TV MOUNTING
BRACKET END CAP (b3), through the TV MOUNTING BRACKET TUBE (g), and exiting through the CENTER HOLE
(a4) of the TV MOUNTING BRACKET TUBE (g). Install a GROMMET (a5) onto the CENTER HOLE (a4).
3.
If through-holes in the four CONSOLE BOSSES (d) are not present, use a 5/16” drill from the top center of the four
console bosses to create through-holes.
Note: Be careful not to damage the threads of the brass inserts when
drilling the through-holes in the console bosses (d).
CAUTION:
Wear eye safety equipment when drilling the through-holes in the console bosses.
4.
Locate the four RETAINING SPACERS (e). Position the RETAINING SPACERS over the CONSOLE BOSSES (d) as
shown. Be sure the RETAINING spacers are fully nested over the structural ribs inside the REAR CONSOLE (f).
5.
Position the BRACKET TUBE (g) with the TV MOUNTING BRACKET PLATE (j) facing upward. Position two
SCREWS (h) on either side through the CONSOLE BOSSES (d). Install four NYLOCK NUTS (i) onto the installed
SCREWS (h) securing the RETAINING SPACERS (e) and BRACKET TUBE (g) to the REAR CONSOLE. Tighten the
NYLOCK NUTS securely. Do not overtighten the NYLOCK NUTS.
To console
connector
a
a1
a3
b3
b
c
a4
b1
b2
a5
g
a2
e
d
h
i
g
f
j
To console
connector
