21
Models:
95X Elevation Inspire & 95X Elevation Discover SI
Tools Required:
Phillips Screwdriver, Metric Allen Set, M16 & M17 Wrench
Parts Not Used From Kit:
(1) Lower Mounting Bracket
For 95X Elevation Inspire Units Only:
a.
Remove the protective liner from one of the provided fastener
strips. Attach the fastener strip to the bottom of the POWER
BLOCK (1). Interlock the remaining fastener strip to the
installed fastener strip. Remove the remaining protective liner
from fastener strip and secure the power block to the underside
of the CENTER FRAME as shown.
Connect the SCREW-TYPE CONNECTOR of the POWER
CORD (2) to the underside receptacle. Bundle excess power
cord and store under the unit. Connect the COAXIAL CABLE
(3) to the broadcast supply receptacle in similar fashion.
b.
Connect the POWER CORD (2) to the POWER BLOCK (1).
1.
Attach the TV BRACKET
(with bent tab) (
4) to the MAIN BRACKET
(5) as shown using four SCREWS (6) and WASHERS (7). Tighten
the screws securely. (8-10 ft. lbs.)
2.
Remove the six SCREWS (8) securing the REAR CONSOLE
COVER (9) to the frame. Remove the rear console cover.
Remove the four SCREWS (10) securing the INSERT (11) as
shown. Set the rear console cover aside.
Remove the CONSOLE (C).
1
3
2
4
7
6
5
11
9
8
10
C
