17
Models:
91TI & 90T
Tools Required: Standard Screwdriver, Phillips Screwdriver, Metric Hex Key Set, Side Cutters
Note:
Proceed with the following steps immediately after attaching the DISPLAY CONSOLE as described in the
91Ti, 90T Treadmill Assembly Instructions
. Do not install the ACCESSORY TRAYS or PUSH RIVETS.
1. Remove the nine SCREWS (a) from the rear of the console
securing the FRONT CONSOLE (b) to the REAR CON-
SOLE (c). Carefully lift the front console. Set the front console
and screws aside.
2. Route the MAIN WIRE HARNESS (D), POWER CORD (d),
and COAXIAL CABLE (e) through the LARGE CABLE
CLIP (f) located at the left inside of the REAR CONSOLE (c).
Route the power cord and coaxial cable through the
large CABLE CLIP (f) located at the center inside of the rear
console. Continue routing the power cord and coaxial
cable through the notch at the top of the rear console.
3. Locate the REMOTE CONTROL (g). Confi gure the REMOTE
CONTROL for a vertical (c-V) installation. Secure the RE -
MOTE CONTROL to the left end of the ERGO CROSSBAR
(13) as shown. Be sure the CABLE TIES (c-v) are pulled tight
and
trim the excess cable ties.
4.
Route the REMOTE CABLE (h) along the LEFT
HANDLE BAR (1). Secure the REMOTE CABLE
using two CABLE TIES (j) at the locations
shown. Be sure the cable ties are pulled
tight and trim the excess cable ties. Route
the remaining REMOTE CABLE through the
CABLE CLIP (k) located on the bottom left of
the REAR CONSOLE (c) and up through the left
access panel. Route the REMOTE CABLE
through the LARGE CABLE CLIP (f) located at
the center inside of the rear console. Continue
routing the REMOTE CABLE through the notch
at the top of the rear console.
5.
Connect the MAIN WIRE HARNESS (D) and
HANDLEBAR WIRE HARNESS (B) to the back
of the FRONT CONSOLE (b). With the POWER
CORD (d), COAXIAL CABLE (e) and REMOTE
CABLE (h) oriented in the top console notch as
shown, secure the FRONT CONSOLE (b) using
the nine previously removed SCREWS (a)
Tighten the screws securely. Replace the access panels.
Note:
Be careful not to pinch the REMOTE CABLE (h) when replacing the access panels.
6.
Install the ACCESSORY TRAYS as instructed in the Assembly Instructions.
7.
Remove the LEFT and RIGHT UPPER HANDLEBAR END CAPS (m) and discard them.
8.
Position the BRACKET TUBE (n) as shown and slide the ends into the HANDRAILS
(1 & 2) until fully seated.
9.
Install the four SET SCREWS (o) into the BRACKET TUBE MOUNTING ARMS (p) and tighten the SET SCREWS
securely. Do not overtighten the set screws.
1
c
e
d
h
D
a
f
k
B
13
g
2
j
h
b
s
t
r
BB
AA
q
b
p
h
d
e
o
m
1
2
h
d
e
