2-24
15
）
Remove the mainshaft comp. and countershaft comp., then check them for
proper match gap. Replace the mainshaft comp. and countershaft comp. if the
gap is too large.
16
）
Check the gears of mainshaft comp. and countershaft comp. for wear.
Replace them if necessary (it needs to replace the gear if defects such as pits,
teeth crack appear).
17
）
Remove the washer of starting mid-gears. Check it for wear and replace it if
the worn part is out of the limit. Service limit: 0.8mm
18
）
Remove the starting mid-gears on the counter shaft. Check it for wear.
Replace it if it is out of the limit.
Limit value of inner bore:
Φ
20.1mm
