Lexmark 5060-00x, Service Manual

Page: 43 / 490

Diagnostic information
2-9
5060-00 x
983 < device > comm Invalid command received by the specified device.
• Engine
• Duplex option
• Tray
x (where x =1,2,3,4, or 5)
• Output bin (where x =1,2,3, or 6)
Note: This message is used for single bin output devices.
• Bin x to y (where x to y=1 to 5).
Note: This message is used for multiple bin output devices.
Check the autoconnects above and below the failing option to make sure
they are seated and connected correctly. Go to service check for the
device indicated.
984 < device > comm Invalid command parameter received by the specified device.
• Engine
• Duplex option
• Tray
x (where x =1,2,3,4, or 5)
• Output bin x (where x =1,2,3, or 6)
Note: This message is used for single bin output devices.
• Bin x to y (where x to y=1 to 5).
Note: This message is used for multiple bin output devices.
Check the autoconnects above and below the failing option to make sure
they are seated and connected correctly. Go to service check for the
device indicated.
990 < device > This error message indicates that an equipment check condition has
occurred in the specified device, but the device is unable to identify the
exact component failure.
Note : < device > can be one of the following:
• Duplex option
• Tray
x (where x =1,2,3,4, or 5)
• Output bin x (where x =1,2,3, or 6)
Note : This message is used for single bin output devices.
Output bin x to y (where x =1 to 5)
Note: This message is used for multiple bin output devices.
Go to the 990 service check for the specified device.
991 < device > Card This error message indicates that a device has detected an equipment
check in its system board.
Note : < device > can be one of the following;
• Duplex option
• Tray
x (where x =1,2,3,4 or 5)
• Output bin x (where x =1,2,3, or 6)
Note: This message is used for single bin output devices.
• Output bin x to y (where x =1 to 5)
Note: This message is used for multiple bin output devices. Go to the
service check for the device indicated.
Go to the service check for the specified device.
1xx service errors
100 ITU Error ITU stall—go to “100 ITU Error” on page 2-42 .
101 ITU Error Invalid ITU memory—replace the ITU. See “ITU assembly removal” on
page 4-37 .
102 ITU Error ITU shorted thermistor—replace the ITU. See “ITU assembly removal”
on page 4-37 .
Error code Action