Lexmark 5060-00x, Service Manual

Page: 218 / 490

3-34
Service Manual
5060-00 x
High-capacity input tray tests
HCIT Standalone Test Mode
This test lets you check out and test the HCIT (2000-Sheet High Capacity Input Tray) without removing any
option or the base printer mounted above the optional HCIT.
Note: During normal operation, the red LED on the HCIT system board blinks or flashes on for one second and
off for one second.
Dip Switch Settings
Do the following steps to set and run the Test/Diagnostic:
1.
Use the dip switch settings table to determine the settings (DSW1 thru DSW4) on the HCIT Control Board
for the test you want to run.
2.
Turn the HCIT power off by moving the LVPS slide switch to the left position.
3.
Press and hold the Push Button Switch PBSW1 while moving the LVPS slide switch to the right position.
The red LED on the HCIT Control board comes on.
4.
Press PBSW1 to feed paper.
5.
Press PBSW1 to stop feeding paper.
Dip switch settings table
DSW1 DSW2 DSW3 DSW4 Mode
Off Off Off N/A Set for shipping
Off Off On N/A The adjustment for the Mirror Reflection Sensors
must be performed anytime the sensors are replaced.
Off On Off N/A EEPROM Initialize
Off On On N/A Not used
On Off Off N/A Paperless Operation Mode
On Off On N/A Self Operation Mode
On On Off N/A Standalone Feeding Operation Mode
On On On N/A Not used