30
The cables have to be plugged in.
The cables are now protected installed
and would not be squeezed anymore.
Final check
Now, the chair has to be driven at min. 2 times in standing and seating Position.
After that, tighten the crews at the actuator unit again
Now the stand-up function could be tested and checked.
Assure that the front wheel lowering cables were behind the gas-springs and
move along the guidance and do not get to be squeezed.
Final works
Positioning and adjustment of the speed
limit switch.
Bring the chair into the most seating
position.
Hold with 1 finger the holder from
underneath and only soft tighten it with 2
screws. Now you can move the switch
easily. Move the switch upwards, until you
hear a
click.
So, the switch is
adjusted.
Now the whole function could be tested and checked.
If everything is OK, assemble the cover of the leg rest assembly, the knee
support, the foot rest and the cushion.
Go into un-tilted position and plug in and position the battery cover.
