18
8.8.
Gas spring exchange for tilt in space
8.9.
Moving the seat to the front or back
8.10.
Exchanging the brake release cable
(only if one hand device / special)
A
A
A
B
C
D
E
Unscrew the two clasp screws (A), cut of the
end cap of the cable and take the cylinder
head (D) off. Now loosen the screw (B) that
is holding the brake release lever. Pull the
lever from the bolt and pull the cables off.
Now pull the cables from the other end (C)
through the magnetic brake levers on the
motor top end.
Enter the new cables the other way around
and mount the brake release lever again.
Now bring the cylinder head (D) to the
position closely to the brake release lever
where the cables are getting through and
fasten the clasp screw (A) of the cylinder
head (D) again.
If you now use the brake release lever, you
should hear a „click“ in the middle of the
braking distance. If this is not the case,
adjust the tension of the cable by adjusting
the cylinder head (D).
Unscrew the 4 screws (A), and then slide the
seat back or forth. When you reach the
required position, put the screws back in and
tighten them again.
Make sure the wheelchair is in the highest
position of the tilt in space function.
Take a screw driver and put it between the
plastic heading and the metal clasp, push the
clasp a couple of millimeters away from the
heading but be careful that the clasp does not
come off. After you have lifted the clasp a bit,
you should be able to remove the gas spring.
Afterwards do the same thing on the other
side.
The new gas spring can just be pushed on
the ball head.