Control panel display AMS 200…
Leuze electronic
AMS 200
27
TNT
3
5/7-2
4
V
6.
3
.2
Parameter - Main menu
Notice
!
Included in the front cover
of this handbook is a
fold-out page
with the complete
param-
eter menu structure
. The parameters are briefly described and the respective default val-
ues are listed.
PROFIBUS:
A detailed description of the individual PROFIBUS parameters can be found in the descrip-
tion of the PROFIBUS GSD modules (chapter 8.1.6 on page 45).
Parameter handling is described in the following chapter.
I
NTERBUS
:
An extensive description of the default settings for Interbus can be found in chapter 8.
Parameter handling is described in the following chapter.
6.
3
.2.1
Parameter handling menu item
Viewing and editing parameters
During normal operation parameters can only be viewed. If parameters need to be changed,
the
ON
menu item in the
Parameter enabling
display mask must be activated (see figure
Notice
!
If a password was set, parameter enabling cannot be accessed until this password has been
entered, see "Password for parameter enabling" on page 29.
The entire display of the AMS 200… is inverted as long as parameter enabling is activated.
Attention
!
Depending on the device version the bus system or interface is deactivated upon activation
of parameter enabling:
PROFIBUS:
The laser measurement system is deactivated on the PROFIBUS when parameter enabling
is activated via the display. The device is reactivated on the PROFIBUS after parameter en-
abling is exited.
SSI:
The SSI interface remains active even during parameter enabling. Changes to parameters
have an immediate effect.
I
NTERBUS
:
The Interbus interface remains active even during parameter enabling. Changes to param-
eters have an immediate effect.
RS 232:
The RS 2
3
2 interface remains active even during parameter enabling. Changes to parame-
ters have an immediate effect.
Summary of Contents for AMS 200
Page 117: ......