Leuze electronic AMS 200, Technical Description, Page: 32 / 118

Control panel display AMS 200…
28 AMS 200 Leuze electronic
Parameter enabling
Figure 6. 3 : Parameter enabling
Notice !
If the AMS 200… is operated on a PROFIBUS network, configuration is performed exclu-
sively via the PROFIBUS.
PROFIBUS: Parameters set via the display are overwritten by the parameters set in the GSD modules
when operating the laser measurement system on the Profibus. For GSD modules which are
not actively used on the PROFIBUS, the default settings of the laser measurement system
apply, see "Detail description of the modules" on page 45. Thus the PROFIBUS presets
values to all parameters.
Attention !
If parameters are changed via the display during bus operation, the laser measurement sys-
tem is separated from the PROFIBUS when parameter enabling is activated via the display.
Parameters set via the PROFIBUS are moved to the background, and changes to parame-
ters can then be made via the display. When parameter enabling is exited, the laser meas-
urement system is automatically reconnected to the PROFIBUS. Upon connection to the
PROFIBUS, the laser measurement system receives all parameters from the PROFIBUS
master.
PROFIBUS: Changes made via the display are overwritten!
Device settings for operating the laser measurement system on the PROFIBUS are
managed and configured exclusively by the PROFIBUS master.
SSI: If the PROFIBUS is deactivated and the laser measurement system transmits its data via
the SSI interface, it may be necessary to adjust the laser parameters via the integrated dis-
play. In this operating mode the PROFIBUS default parameters have no effect; the SSI de-
fault parameter set applies (see chapter 8.2.4).
Settings made on the display apply permanently. As the parameters are only stored in the
device in this operating mode, the parameters must be reset on the replacement device if
device replacement is required.
E S C
E S C
E S C