Leuze electronic AMS 200, Technical Description, Page: 24 / 118

Reflectors
20 AMS 200 Leuze electronic
5. 3 Selecting reflector sizes
Depending on the system design, the reflector may either be mounted on the moving vehicle
or in a stationary location.
Attention !
The reflector sizes shown below are recommended by Leuze electronic for mounting the
AMS 200 on a vehicle. The system supplier must always perform a check to determine
whether a larger reflector than the one recommended has to be used by reason of mechan-
ical travel tolerances. This applies, in particular, when the laser measurement system is
mounted on a vehicle. The laser beam must not leave the reflector during travel. For station-
ary mounting of the AMS 200, a small 200 x 200 mm reflector will be adequate for all meas-
urement distances.
5.4 Dimensioned drawing of reflectors
Figure 5.1: Dimensioned drawing of reflectors
Recommended reflector sizes
Laser measurement system
(range in m)
Recommended
reflector size
(H x W)
Type designation
…-S = Self-adhesive
…-M = Mounted Part No.
AMS 200/40… ( max. 40 m ) 200 x 200 mm
Reflective tape 200x200-S
Reflective tape 200x200-M 50104 3 61
50104 3 64
AMS 200/120… ( max. 120 m ) 500 x 500 mm
Reflective tape 500x500-S
Reflective tape 500x500-M 50104 3 62
50104 3 65
AMS 200/200… ( max. 200 m )
749 x 914 mm
914 x 914 mm
Reflective tape 749x914-S
Reflective tape 914x914-M
Reflective tape 914x914-S 50104 3 6 3
50104 3 66
50108988
Always align the TOP
marking with the AMS
connections! (chapter 5.1)