Letatwin LM390, User Manual

Page: 16 / 75

Fel! Använd fliken Start om du vill tillämpa
見出し
1 för texten som ska visas här.
16
2-8 ADJUSTING THE HALF CUTTING DEPTH
Half cutting depth can be adjusted with the ” Half cutting depth adjustment lever ”, when half
cutting depth is not adequate.
Note:
● When printing on tubes, the lever has to be
positioned on the “ TUBE .”
● When printing on tape, the lever has to be
positioned on the “ TAPE .”
2-9 SWITCHING THE PRINTING PRESSURE
Printing pressure can be adjusted with the “Printing pressure switching lever.”
Note: You don’t need to change the strength unless the printed result is too dark.
(Changing from the standard pressure to the low pressure)
1. Check that the release lever is at the
middle position. (The lever is standing)
2. While pressing the lock button, then slide
the printing pressure switching lever to
the right.
3. Now, the strength of the printing pressure
is low.
(Changing from the low pressure to the standard pressure)
1. Check that the release lever is at the
middle position. (The lever is standing).
2. Press the lock button.
Note: Don’t change the head pressure when
the head release lever is positioned as
the figure (“Open” position or “Close”
position).
Deep
Shallow
The release lever is
standing.
Low position
(1)
(2)
“Open”
“Close”