Firmware
≤
11.00 - DMS 8.0 EN - 10/2011
L
77
8400 StateLine C | Reference manual
Device control (DCTRL)
Device commands (C00002/x)
Activate device command
When an online connection has been established, simply use the »Engineer« to activate a
device command by selecting the corresponding option from the
Parameters
tab in
C00002/x
("0: off" or "1: On / start").
Alternatively, the device command can also be activated via e.g. keypad or through a
master control by writing to
C00002/x
.
Some of the frequently used device commands (such as "Save parameter set") can also
be executed via the
Toolbar
icons of the »Engineer« when an online connection has
been established:
Symbol
Function
Enable controller
Inhibit controller
Save parameter set (for 8400: Save all parameter sets)
Note!
Device commands that can be executed via the
Toolbar
of the »Engineer« always
affect the element currently selected in the
Project view
including all
subelements!
• If no controller but e.g. a system module is selected in the
Project view
instead, the corresponding device command will be activated in all lower-
level controllers that have an online connection to the »Engineer«.
Before the desired action is carried out, a confirmation prompt appears first,
asking whether the action is really to be carried out.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
