Lenze 8200 vector series, Mounting Instructions

Page: 161 / 250

Troubleshooting and fault elimination
Fault elimination
Fault messages
8
161
EDK82EV222 DE/EN/FR 13.0
Remedy Cause Fault PC
1)
Keypad
OH
$
50 Heatsink
temperature > +85
°C Ambient temperature is too high Allow controller to cool and provide
for better ventilation
OH
%
− Heatsink
temperature > +80
°C Heatsink is very dirty Clean heatsink
OH
%
− Heatsink
temperature > +80
°C Impermissible high currents or
frequent and too long
acceleration processes l Check drive dimensioning
l
Check load, replace
rough−running, defective
bearings, if necessary
OH3
$
53 PTC monitoring
(TRIP)
(display when
C0119 = 1 or 4) Motor too hot due to
impermissible high currents or
frequent and too long
acceleration processes Check drive dimensioning
No PTC connected Connect PTC or switch off monitoring
OH4
$
54 Controller
overtemperature Controller is too hot inside l Reduce controller load
l Improve cooling
l Check fan in the controller
OH51
203 PTC monitoring
(display when
C0119 = 2 or 5) Motor too hot due to
impermissible high currents or
frequent and too long
acceleration processes Check drive dimensioning
No PTC connected Connect PTC or switch off monitoring
OU
− DC−bus overvoltage
(message or TRIP
configurable in
C0310) Mains voltage is too high Check supply voltage
OUE
$
22 Braking operation l Increase deceleration times
l For operation with an external
brake resistor:
– Check dimensioning,
connection and supply cable of
the brake resistor
– Increase deceleration times
Earth leakage at motor end Check motor supply cable and motor
for earth fault (disconnect motor
from the inverter)