Lenovo TP00052A User Manual Download

Page: 70 / 184

b. In the

Enter New Password

field, type the new supervisor password; then retype the password

you just entered to verify it in the

Confirm New Password

field. Press Enter.

• To remove a password, do the following:

a. In the

Enter Current Password

field, type the current supervisor password and press Enter.

b. Leave the

Enter New Password

and

Confirm New Password

fields blank. Press Enter.

Attention:

You might want to note down your password and keep it in a safe place. If you forget your

supervisor password, Lenovo cannot reset your password. You must take your computer to a Lenovo
reseller or a Lenovo marketing representative to have the system board replaced. Proof of purchase is
required, and a fee will be charged for parts and service.

9. In the Setup Notice window that is displayed, press Enter to continue.

10. Press Fn+F10. The Setup Confirmation window opens. Select

Yes

to save configuration changes

and exit.

The next time you open the ThinkPad Setup program, you will be prompted to type your password to proceed.

Hard disk security

To protect passwords from unauthorized security attacks, several of the latest technologies and algorithms
are integrated into UEFI BIOS and hardware design of ThinkPad notebook computers.

To maximize security, do the following:

1. Set a power-on password as well as a hard disk password for your internal solid-state drive or hard disk

drive. Refer to the procedures in “Power-on password” on page 50 and “Hard disk passwords” on page
50. For security, a longer password is recommended.

2. If a Disk Encryption hard disk drive or a Disk Encryption solid-state drive is installed in your computer,

be sure to protect the contents of your computer memory from unauthorized access by use of drive
encryption software.

3. Before you dispose of, sell, or hand over your computer, be sure to delete data stored on it. Refer to

“Notice on deleting data from your hard disk drive or solid-state drive” on page 56.

Note:

The hard disk drive built into your computer can be protected by UEFI BIOS.

Disk Encryption hard disk drive and Encryption solid-state drive

Some models contain the Disk Encryption hard disk drive or Encryption solid-state drive. This feature helps
to protect your computer against security attacks on media, NAND flash or device controllers by use of
a hardware encryption chip. For the efficient use of the encryption feature, be sure to set a hard disk
password for the internal storage device.

Using the fingerprint reader

Your computer might have an integrated fingerprint reader. Fingerprint authentication can replace passwords
and enable simple and secure user access. By enrolling your fingerprint and associating it with a Windows
password, you can log on to the computer by swiping your finger over the reader, without typing passwords.

Enrolling your fingerprint

To use the integrated fingerprint reader, begin by enrolling your fingerprint as follows:

1. Turn on your computer.

User Guide