Lenovo ThinkServer RD350G, User Manual And Hardware Maintenance Manual

Page: 62 / 186

3. Press F10 to save settings and exit the Setup Utility program. The server will follow the startup device
sequence you have set each time you turn on the server.
Configuring the TPM function
The TPM works as a hardware security solution to help you to encrypt data and protect the server. The TPM
function is only available when there is a TPM installed in your server. See
“Installing the TPM” on page 71.
You can purchase a TPM from the Lenovo Web site at:
http://lenovoquickpick.com/usa/home/thinkserver/rack-and-tower-server
After installing a TPM, check if the TPM function is enabled in the Setup Utility program.
To enable the TPM function in the Setup Utility program, do the following:
1. Start the Setup Utility program. See
“Starting the Setup Utility program” on page 43.
2. On the System Security menu, select TPM Settings
➙
TPM Support .
3. Do one of the following:
• If
TPM Support is set to Enabled , the TPM Security Feature item is displayed. Set TPM Security
Feature to Activate .
• If
TPM Support is set to Disabled , do the following:
a. Set TPM Support to Enabled and press F10 to save settings and exit the Setup Utility program.
The server will restart.
b. Start the Setup Utility program. On the System Security menu, select TPM Settings . Then, set
TPM Security Feature to Activate .
4. Press F10 to save settings and exit the Setup Utility program. The server will restart to enable the
TPM function.
Setting an Ethernet connector for system management
There are three RJ-45 Ethernet connectors on the rear of the server. The Ethernet connector 0 is for system
management by default. However, you also can set the Ethernet connector 1 for system management use.
To locate the three Ethernet connectors, see
“Rear view of the server” on page 21.
To set the Ethernet connector for system management, do the following:
1. Start the Setup Utility program. See
“Starting the Setup Utility program” on page 43.
2. On the TSM Settings menu, select TSM Network Settings
➙
TSM NIC Selection .
3. Do one of the following:
• To set the Ethernet connector 0 for system management, select
Dedicated Port .
• To set the Ethernet connector 1 for system management, select
Shared NIC Port .
4. Press F10 to save settings and exit the Setup Utility program.
Exiting the Setup Utility program
After you finish viewing or changing settings, press Esc to return to the Setup Utility program main interface.
If you are on a nested submenu, press Esc repeatedly until you reach the main interface. Then, you can do
one of the following to exit the Setup Utility program:
• If you want to save the new settings and exit the Setup Utility program, press F10 or select
Save & Exit
➙
Save Changes and Reset . Otherwise, your changes will not be saved.
• If you do not want to save the new settings, select
Save & Exit
➙
Discard Changes and Exit .
• If you want to return to the default settings, press F9 or select
Save & Exit
➙
Load Optimized Defaults .
48
ThinkServer RD350G User Guide and Hardware Maintenance Manual