Lenel LNL-3300-M5, Installation Manual

Page: 146 / 184

LNL-1340-M2K Four Reader interface Module
146 —
revision 7
facilitate proper reporting. The standard supervised circuit requires 1K Ohm, 1% resistors and should be
located as close to the sensor as possible. Custom End-of-Line (EOL) resistances may be configured via the
host software.
* Grounded and foreign voltage states are not UL 294 required and therefore not verified by UL.
The input circuit wiring configurations shown are supported, but may not be typical:
LNL-1340-M2K Input Wiring - Supervised and Non-supervised
Warning
Door position monitor and REX inputs must be wired to the LNL-1340-M2K when using F/2F readers. EOL
resistors are typically two 1K ohm resistors as shown below. The EOL resistors should be installed as close
to the switch as possible.
LNL-1340-M2K Input Wiring - Supervised and Non-supervised Callouts
Callout Description
1 Standard supervised circuit; normally closed contact
2 Standard supervised circuit; normally open contact
3 Unsupervised circuit; normally closed contact
4 Unsupervised circuit; normally open contact
5 Terminal Blocks: TB1 (Inputs 1-5) and TB2 (Inputs 6-10) on LNL-1340-M2K
1K,1%
1K,1%
1K,1%
1K,1%
1
5
2
3
4