Lenel LNL-3300-M5, Installation Manual, Page: 12 / 184

Hardware Installation Guidelines
12 —
revision 7
2 Installation
2.1 Installation Outline
The following is a basic outline for installing and setting up the Lenel M Series system. Some steps may
have been done depending on what was ordered. Some steps are optional, depending on the additional
equipment to be used. These steps are noted.
Important: Do not apply power to any component until the installation is complete. Damage
to the components may occur if power is incorrectly applied.
1. Determine the cable clamps needed and obtain them before starting the installation.
During the installation, remember to:
•
Label all connections/cables for ease of maintenance.
• Leave enough slack in the wiring so the cables can be “dressed”. This minimizes interference
during board removal or replacement.
2. Unpack your system. Refer to Introduction on page 11 .
3. Mount the enclosure. Refer to Mounting on page 14 .
4. Mount and install the power supply. Refer to Installing the Power Supply on page 17 .
5. Mount and install the battery backup. Refer to Installing the Battery Backup on page 19 .
6. Wire up the LNL-3300-M5 ISC. Be sure to configure and verify the switch settings. Refer to Wiring on
page 45 .
7. If using networked controllers, verify that your network is up and running.
8. Install the reader board(s) into the enclosure and wire up the readers to the controller. Be sure to
configure and verify the switch settings, jumpers, and/or resistor packs.
9. If using digital inputs, insert the LNL-1100-DI into the enclosure and wire the inputs to the board. Be
sure to configure and verify the switch settings. Refer to Overview of the LNL-1100-20DI on page 57 .
10. If using digital outputs, insert either the LNL-1200-16DO or LNL-1200-16DOR into the enclosure and
wire the outputs to the board. Be sure to configure and verify the switch settings. Refer to Overview of
the LNL-1200-16DO on page 67 and Overview of the LNL-1200-16DOR on page 77 .
11. Test the wiring before you apply power. Refer to Pre-Power Up Testing on page 22
12. Configure your controller. Configure the controller using the Integrated Configuration Tool (ICT).
Refer to Web Configuration on page 47 .