Lektri-Co SVIK, User And Installation Manual

Page: 18 / 36

SVIK user and installation manual 18
8. Insert the power supply cable through the rear cut-out hole. If the
bottom left cut-out hole is used skip this step.
9. Fix the main body of the charger on the wall by inserting the screws
through the mounting points and tighten them with a screwdriver
by hand.
CAUTION
Overtightening the screws may cause the plastic
enclosure of the charger to break.
10. Insert the seal and the sealing nut of the provided cable gland onto
the power supply cable.
11. Install the cable gland in the bottom left cut-out area created at step
7. Fix the cable gland into position by tightening the lock nut.
12. Strip the main insulation of the power supply cable in such a way
that 2 cm of insulation will be left inside the plastic enclosure of the
charger.
13. Measure and cut the 3-wires of the power supply cable, in such a way
that they can be easily and fully inserted into the cable connectors
Fig. 6 Mounting points of the SVIK