Lektri-Co SVIK, User And Installation Manual

Page: 27 / 36

SVIK user and installation manual 27
5. OPERATING THE SVIK CHARGER
5.1. BEFORE FIRST USE
Before charger’s first use :
1. Make sure the charger was properly installed and it is safe to use.
For proper installation follow the instructions described in chapter 4.
SVIK installation.
2. Using the SVIK web portal or the application, check the charger’s
configuration (e.g. maximum charging current, authentication
required for charging). For more details see chapter 6. SVIK
CHARGER CONFIGURATION.
3. The front cover LED is green, fading in and out, meaning that the
charger is available and unused (not connected to the electric
vehicle). For more details about front cover LED different states see
section 3.6 LED status.
5.2. START THE CHARGING
To start the charging process, connect the charging cable to the
electric vehicle and make sure is locked. The SVIK charger is starting to
communicate with the car through the type 2 connector. The front cover
LED will continuously light blue. After the car starts the charging process
the front cover LED will start to light white and each segment is lit in a
continuously rotating pattern.
5.3. STOP THE CHARGING
When the charging process is finished the front cover LED will light
continuously blue.
Access the SVIK web portal or the application to stop the charging before
the electrical car is fully charged.
After the charging process is finished or stopped disconnect the type 2
connector from the car and wrap the charging cable around the main
body of the charger in such a way that the connector and the charging
cable do not touch the ground.
5.4. EMERGENCY STOP
In case of a fatal error or if smoke or fire is visible an emergency stop is