Lektri-Co SVIK, User And Installation Manual

Page: 29 / 36

SVIK user and installation manual 29
6. SVIK CHARGER CONFIGURATION
To configure the SVIK charger use the dedicated LEKTRI.CO app.
Alternatively you can manually access the chargers setting using the web
interface (see chapter 7)
The following parameters can be configured:
1. Maximum charging current.
In the Allowed current (A) field, set the maximum allowed current
for charging the electric vehicle. The charging current can be set
from 6A to 32A, corresponding to a power of 1.4kW to 7.4kW. It is
recommended that this parameter is configured immediately after
the installation of the SVIK charger.
2. Authentication operation mode.
SVIK charger can be configured to function with or without cloud
base authentication. To enable the authentication, slide the button
near the Authentication required for charging. If this operation
mode is enabled the charging process will start only after successful
authentication. Not enabling this operation mode means that
the charging process will start automatically when the charger’s
connector is plugged into the electric vehicle (plug & charge).
3. LED brightness
Using the slide bar under the LED Brightness field the intensity of
the front cover LED can be configured. Sliding the bar to the left
will decrease the LED brightness and sliding the bar to the right will
increase the LED brightness.