Lektri-Co SVIK, User And Installation Manual

Page: 17 / 36

SVIK user and installation manual 17
recommendations of the anchor screw manufacturer. Anchor screws
and corresponding screws are not included.
6. Insert the anchor screws into the holes and make sure they are
inserted all the way. If necessary, use a hammer and gently tap the
anchor screws all the way into the holes.
7. Using a step drill bit, drill a 30mm diameter hole into one of the
existing precut areas from the plastic enclosure. These easy to cut
areas are used to insert the power supply cable into the main body of
the charger.
There are 2 available easy to cut areas through which the power
supply cable can be inserted into the charger. One area is on the rear
of the enclosure and one area is on the bottom left side.
Fig. 5 Cut out areas for the power supply cable