iNEX User Manual
Page
9 Rev
2
2.5
Connecting Remote Master Switch
The iNEX is designed to sense 12-volts DC from a master switch, which
when configured will activate the treatment recording function on the
iNEX.
It is recommended that the Remote Master Switch is connected to an
existing master switch in the vehicle, however there are many options
including 12-volts DC from a master valve, an implement switch or a
separate toggle switch.
1.
Connect a wire to the 12-volt positive on/off source, such as an
existing master switch.
2.
Connect the other end of the wire to the Remote Master Switch
(brown cable) on the iNEX Vehicle Cable.
3.
Consult the iNEX user manual for instruction on configuring the
system to use the Remote Master Switch as the master switch
source.
Note: The iNEX will detect 12-volt positive as the master switch being on and no power
as the master switch being off.
2.6
Connecting Remote Input
The Remote Input can be connected to a momentary push-button switch
which can then remotely trigger a user defined function on the iNEX, such
as engage/disengage auto steering.
1.
Connect 12-volts to one side of a momentary push-button switch.
2.
Connect a wire from the other side of the momentary push-button
switch to the Remote Input (white cable) on the iNEX Vehicle Cable.
3.
Consult the iNEX user manual for instruction on configuring the
Remote Button function to be triggered by the Remote Input.
Note: The 12-volts DC supplied to the Remote Master Switch and the Remote Input
MUST be on the same 12-volt DC circuit to which the iNEX is connected.
