iNEX User Manual
Page
23 Rev
2
Touch
When set to Touch the master switch can be turned ON
and OFF by touching on the Master Switch Status in the
Virtual Road Window. Optionally the master switch can
also be turned ON and OFF by pressing a Remote Button
configured for Rove/Record (see section 7.5 Configuring
Remote Buttons).
Sense
The master switch is turned ON when voltage is applied
to the master switch Input pin and turned OFF when
voltage is removed. Using this method will allow the
system to detect an existing master switch in the
vehicle. For more information see section 2.5
Connecting Remote Master Switch.
Sense Dipole
Similar to Sense the Sense Dipole setting can be used to
sense an existing master switch in a vehicle. In this case
Sense Dipole will sense a switch which operates by
reversing the polarity.
To use the Sense Dipole option an AS310 is required.
For more information see the iNEX Installation Manual.
Flow Controller When the Flow Controller setting is used the system will
detect the Master Switch Status from the selected flow
controller. To use this option a flow controller must be
selected for the current Rig (see section 3.5.2.2
Configure Advanced Settings).
For some controllers it is not possible to use the Flow
Controller setting when AutoSPRAY is ON. If this is the
case then the master switch will not be detected until
the Master Switch Setup is changed or AutoSPRAY is
turned OFF.
