Leica HistoCore Arcadia H, Instructions For Use Manual

Page: 32 / 50

32 Version 1.8, Revision K
Operation
5
Setting the Start time
Fig. 20
2 6 4
The Start time is the time at which the instrument automatically enters operating mode.
1. Touch the
Setup
( → Fig. 17- 14 ) button.
2. Touch the Enter ( → Fig. 17- 18 ) button as many times as required until the icon of Start time
( → Fig. 20- 2 ) shows up and the value of Hour flashes.
3. Set the Hour with the Up ( → Fig. 17- 22 ) / Down ( → Fig. 17- 17 ) buttons.
Press the Up / Down button for more than 2 seconds, and the setting value is changed
continuously.
4. Touch the
Right
( → Fig. 17- 21 ) button and the value of the Minute flashes.
5. Set the Minute with the
Up
( → Fig. 17- 22 ) /
Down
( → Fig. 17- 17 ) buttons.
If 12-hour format is selected, touch the Right ( → Fig. 17- 21 ) button and use the Up
( → Fig. 17- 22 ) / Down ( → Fig. 17- 17 ) buttons to set am and pm.
6. Touch the Enter (
→
Fig. 17- 18 ) button to save the setting.
Setting the End time
The End time is the time at which the instrument automatically switches from operating mode to
standby.
1. Touch the Setup (
→
Fig. 17- 14 ) button.
2. Touch the Enter (
→
Fig. 17- 18 ) button as many times as required until the icon of End time
( → Fig. 20- 6 ) shows up and the value of Hour flashes.
3. Follow steps 3, 4, 5 and 6 in the
Setting the Start time
, to set the End time.
After the Start time and End time are set, switch off and on the instrument using the physical button
( → Fig. 15- 9 ) , and the scheduler icon is displayed on the control panel ( → Fig. 20- 4 ) .
To disable the scheduler ( → p. 33 – 5.4 Operation modes) .
Warning
• The scheduler works only when the instrument is powered on.
• The Start time and End time are still effective in the standby mode.